I'll be helping a close friend install a sub into "RAMcracker" his NICE 2500 CTD ! I helped with a simple system in his Trans Am, that turned out GREAT ! (Kenwood Excelon H/U to PG ZX500.4 TI: front channels Infinity 6&1 component set and MB Q mids, rear channels bridged to 10" Infinity sub)
1st I need a source / recommendation for a good LOC ?
2nd where should I tap into the factory setup (Infinity option I believe) for proper L&R signal ?
He purchased another PG TI (ZX400.2, he loves the 500.4) that will run bridged mono at 4 ohms to a 10" sub in a box that replaced the lower center console section of the front seat (truck is a manual)
TIA ! ~DaVe
1st I need a source / recommendation for a good LOC ?
2nd where should I tap into the factory setup (Infinity option I believe) for proper L&R signal ?
He purchased another PG TI (ZX400.2, he loves the 500.4) that will run bridged mono at 4 ohms to a 10" sub in a box that replaced the lower center console section of the front seat (truck is a manual)
TIA ! ~DaVe