Hey all,
I've got an Alpine PDX-5 driving the following:
The DXi's are 4 ohm speakers, however, the measured impedance was only 2.8 ohms for all of them (the subwoofer measured at 3.7 ohms, which is on-par in my book).
Is this common, or is something botched? To measure, I simply set the multimeter to the 20 ohm setting and measured through the hot-plug connectors that Alpine provides (disconnect from the amp first, of course).
I've got an Alpine PDX-5 driving the following:
- DXi 6500 components (front)
- DXi 650 coaxials (rear)
- DB1040 SVC subwoofer
The DXi's are 4 ohm speakers, however, the measured impedance was only 2.8 ohms for all of them (the subwoofer measured at 3.7 ohms, which is on-par in my book).
Is this common, or is something botched? To measure, I simply set the multimeter to the 20 ohm setting and measured through the hot-plug connectors that Alpine provides (disconnect from the amp first, of course).