So ive pretty much decided on 2 pairs of Polk Audio 651 coaxials since i can get them for $120 to $130 area & they can handle up to 100rms. If anyone has any further selections within the $150 budget then im willing to listen but i think these along with a proper installation will do just fine.
I have a Lanzar MXA422 that has to do the job & here are the specs:
4 x 250 Watts RMS at 4 Ohms
4 x 500 Watts Max at 4 Ohms
2 x 1000 Watts Max at 4 Ohms Bridged
4 x 450 Watts at 2 Ohms RMS
Electronic Crossover Network
Bass Boost Circuit
Variable Phase Shift Control
2 Ohms Stereo Stable
Anti-Thump Turn-On
Tri-Mode Configurable
Soft Turn On/Off
High Low Level Inputs
Blue Light Illuminated Crossover Control
Power Protection LED Indicators
Advanced Protection Circuitry
Bass Boost Remote Control
T.H.D:<0.04%
S/N Ratio:>90dB
Channel Separation:<65dB
Frequency Response: 15Hz- 35kHz
Dimensions: 10.47''W x 2.46''H x 17''L
So my question is, how do i wire those speakers & that amp to send the 2 ohm load to them?? (sorry ive never understood what Ohms are in a speaker in years!)
Thanks!!!
I have a Lanzar MXA422 that has to do the job & here are the specs:
4 x 250 Watts RMS at 4 Ohms
4 x 500 Watts Max at 4 Ohms
2 x 1000 Watts Max at 4 Ohms Bridged
4 x 450 Watts at 2 Ohms RMS
Electronic Crossover Network
Bass Boost Circuit
Variable Phase Shift Control
2 Ohms Stereo Stable
Anti-Thump Turn-On
Tri-Mode Configurable
Soft Turn On/Off
High Low Level Inputs
Blue Light Illuminated Crossover Control
Power Protection LED Indicators
Advanced Protection Circuitry
Bass Boost Remote Control
T.H.D:<0.04%
S/N Ratio:>90dB
Channel Separation:<65dB
Frequency Response: 15Hz- 35kHz
Dimensions: 10.47''W x 2.46''H x 17''L
So my question is, how do i wire those speakers & that amp to send the 2 ohm load to them?? (sorry ive never understood what Ohms are in a speaker in years!)
Thanks!!!