I was on partsexpress.com and checking out Dayton HO and Peerless XLS subs. And then I read Q&As about recommended enclosures, both subs the techs recommended ported enclosures given the Parameters. So I'm wondering if the JL 10w6v2 requires a ported enclosure. Here are the parameters.
Free Air Resonance (Fs) 28.5 Hz
Electrical Q (Qes) 0.497
Mechanical Q (Qms) 8.458
Total Speaker Q (Qts) 0.469
Equivalent Compliance (Vas) 1.18 cu ft / 33.4 L
One-Way Linear Excursion (Xmax)* 0.60 in / 15 mm
Reference Efficiency (no) 0.15%
Efficiency (1 W / 1 m)** 83.7 dB SPL
Effective Piston Area (Sd) 51.4 sq in / 0.0332 sq m
DC Resistance (Re)*** 6.3 Ω
BTW, can someone model me a ported enclosure? JL recommends a .75 cu ft enclosure tuned to 37hz. That's a very small enclosure and a relatively high tune.
Free Air Resonance (Fs) 28.5 Hz
Electrical Q (Qes) 0.497
Mechanical Q (Qms) 8.458
Total Speaker Q (Qts) 0.469
Equivalent Compliance (Vas) 1.18 cu ft / 33.4 L
One-Way Linear Excursion (Xmax)* 0.60 in / 15 mm
Reference Efficiency (no) 0.15%
Efficiency (1 W / 1 m)** 83.7 dB SPL
Effective Piston Area (Sd) 51.4 sq in / 0.0332 sq m
DC Resistance (Re)*** 6.3 Ω
BTW, can someone model me a ported enclosure? JL recommends a .75 cu ft enclosure tuned to 37hz. That's a very small enclosure and a relatively high tune.