Not sure what the terminology is for this setup, but I'm talking about connecting power to an amp. Strip ~ 10mm of insulation, insert wire into hole, then tighten hex screw down from the top. See my attached pic.
My question is whether any of you use some kind of a connector on the end of the wire. I'm thinking of something that will prevent the wire from fraying if you are connecting/reconnecting a lot.
Thanks for any insight you can provide!
My question is whether any of you use some kind of a connector on the end of the wire. I'm thinking of something that will prevent the wire from fraying if you are connecting/reconnecting a lot.
Thanks for any insight you can provide!