I bought the XR-1s monoblock amp to run my DVC (4 ohm) sub wired in parallel for a 2-ohm load. However, the XR-1s manual is confusing. Here's what it says:
Specifications
CEA-2006 Standard
600 W x 1
RMS Watts per channel @ 4 ohms, 1% THD+N
83 dBA Signal to Noise Ratio (Reference: 1 Watt into 4 ohms)
Max power Output 1500 W
Rated power Output
14.4 V
600 W x 1 (4Ω) (20 Hz - 200 Hz, 1.0% THD)
700 W x 1 (2Ω) (100 Hz, 1.0% THD)
Frequency Response 20-200Hz(±1dB)
Input Sensitivity 0.2 V - 5.0 V (MIN-MAX)
Input Impedance 10 kΩ
Signal to Noise Ratio 105 dB
Low Pass Filter Frequency
(-12 dB/oct.)
50 Hz - 200 Hz (variable) Low-Pass Filter Frequency
High Pass Filter Frequency -
Dimensions (W x H x D)
235 x 52 x 192 mm
9-1/4 x 2-1/16 x 7-9/16 inch
Does this mean I only get 100Hz when run in 2-ohm mode? Or, do I get 20Hz-100Hz (which would be fine).
Specifications
CEA-2006 Standard
600 W x 1
RMS Watts per channel @ 4 ohms, 1% THD+N
83 dBA Signal to Noise Ratio (Reference: 1 Watt into 4 ohms)
Max power Output 1500 W
Rated power Output
14.4 V
600 W x 1 (4Ω) (20 Hz - 200 Hz, 1.0% THD)
700 W x 1 (2Ω) (100 Hz, 1.0% THD)
Frequency Response 20-200Hz(±1dB)
Input Sensitivity 0.2 V - 5.0 V (MIN-MAX)
Input Impedance 10 kΩ
Signal to Noise Ratio 105 dB
Low Pass Filter Frequency
(-12 dB/oct.)
50 Hz - 200 Hz (variable) Low-Pass Filter Frequency
High Pass Filter Frequency -
Dimensions (W x H x D)
235 x 52 x 192 mm
9-1/4 x 2-1/16 x 7-9/16 inch
Does this mean I only get 100Hz when run in 2-ohm mode? Or, do I get 20Hz-100Hz (which would be fine).